TH Video - How to install Thermal sensor TS-100 for 3D LIGHT
The following video briefly shows how to install the thermal sensor module in a 3D LIGHT (former name: 2D EYE).
Thus, the device is updgraded to the TBS 3D LIGHT THERMAL.
Related Articles
Video - How to replace sensor in 3D TERMINAL
The following video explains step by step how to replace the sensor in TBS 3D TERMINAL. Please follow the steps carefully:
HowTo - Resolve 3D sensor errors
The sensor in 3D AIR (Model 2012, former 3D TERMINAL) is not working stably and sensor runtime issues are reported regularly Solution If firmware is not able to load sensor at startup or report sensor run-time issues (error codes 42/412/414), it may ...
HowTo - 3D Sensor-Probleme beheben
Der Sensor im 3D AIR (Modell 2012, ehemals 3D TERMINAL) arbeitet nicht stabil und es werden regelmässig 'sensor runtime' Fehlermeldungen angezeigt. Lösung Falls die Firmware den Sensor beim Start nicht korrekt laden kann oder einen Sensor runtime ...
HowTo - Resolve 3D AIR GEN2 finger positioning problems
Symptoms: (1) 3D AIR GEN2 shows the error : "Move upward/downward" while positioning the fingerprint and fail to capture the fingerprint. (2) The 3D AIR GEN2 Sensor doesn't read the fingerprints at all. Solution: In most cases, this issue occurs ...
Video - How to install RFID module in 2D IRON or 3D AIR (Gen 3)
To install an RFID module in 2D IRON or in a 3D AIR (Gen 3) device, please follow the procedure in this video: The installation of an RFID module in 3D AIR (Gen 3) is shown in these pictures: